Home / Repair parts
Keep it running
A Vacumaid is built to be repaired, not replaced. Every wear part — motor, bag, filter, board — is available through your authorized dealer, often for models over 20 years old.
The most common maintenance items — replace bags 2 to 3 times a year to keep full suction.
Most requestedHigh-filtration bags for SR and P series units. Sold in packs of 3.
Secondary filters that protect the motor and clean the exhaust air.
Lid and canister gaskets — a worn seal is the #1 cause of lost suction.
Replacement bags for the DC500 bag collector.
Installed by your dealer — a motor swap typically gives your unit a second life for a fraction of the cost of a new system.
Genuine motors for every current and discontinued Vacumaid unit.
Control boards, relays and low-voltage transformers.
Replacing worn carbon brushes can save a motor before it fails.
Power cords, unit switches and inlet contacts.
Repair instead of replacing: handles, ends and brush rolls are all serviceable.
Replacement handles and handle switches for electric and low-voltage hoses.
Wall ends and swivel cuffs — a loose end is an easy fix.
Brush rolls, belts and neck assemblies for power brushes.
Telescopic wands and locking buttons, compatible with all handles.
The model number is on the label on the side of your unit (e.g. SR66, SR12S, P70).
Your local dealer identifies the exact genuine part — even for discontinued models.
Simple parts you install yourself; for motors and boards, most dealers repair on site.
Call us or visit your nearest dealer with your model number — we'll figure it out together.